[rancid] Unable to Conduct Cisco Wireless Controller Backup

[Piegorsch, Weylin William]

I did some experimenting, issuing the "config paging disable" CLI command on initial login seems to eliminate the paging issue, similar to the ASA "terminal pager 0" or the IOS "terminal length 0".
weylin

On 7/27/18, 8:01 AM, "Piegorsch, Weylin William" <weylin at bu.edu> wrote:

    When I login as myself and run the "show sysinfo" command, I get the below output.  I notice that rancid (wlogin) gets stuck on the prompt at the end there.  When expect sees the prompt, a <space> would be the appropriate response.  I'm not sure how to disable paging, unfortunately. 
    
    Weylin
    
    (cumm111-wism-aca05) >show sysinfo
    
    Manufacturer's Name.............................. Cisco Systems Inc.
    Product Name..................................... Cisco Controller
    Product Version.................................. 8.2.166.0
    Bootloader Version............................... 1.0.20
    Field Recovery Image Version..................... 7.6.101.1
    Firmware Version................................. FPGA 1.7, Env 0.0, USB console 2.2
    Build Type....................................... DATA + WPS
    
    System Name...................................... cumm111-wism-aca05
    System Location.................................. 111 Cummington St., Room B05
    System Contact................................... Network Operations Center
    System ObjectID.................................. 1.3.6.1.4.1.9.1.1293
    Redundancy Mode.................................. SSO
    IP Address....................................... 10.123.18.234
    IPv6 Address..................................... ::
    Last Reset....................................... Software reset
    System Up Time................................... 97 days 17 hrs 26 mins 34 secs
    System Timezone Location......................... (GMT -5:00) Eastern Time (US and Canada)
    System Stats Realtime Interval................... 5
    System Stats Normal Interval..................... 180
    
    
    --More-- or (q)uit
    
    
    
    
    
    On 7/26/18, 6:43 PM, "heasley" <heas at shrubbery.net> wrote:
    
        Thu, Jul 26, 2018 at 09:20:42PM +0000, Piegorsch, Weylin William:
        > I should note that using the NOPIPE=yes thing causes the "controller wlogin error: Error: Connection closed (ssh): controller" message that I show below.  If I omit the NOPIPE environment variable on the CLI, I get the output I showed in the other email, where it hangs in the middle of output.
        > 
        > weylin
        
        i dont see the problem in what you've provided; you'll have to share more
        output with me.
        
        eval `rancid -t cisco-wlc8 -C hostname` &> output