|
|
This chapter describes messages issued for the IPCS Trace Message facility. These messages include T00VE001 through T00VE999.
Explanation A call to the IPCS routine to access storage failed.
Recommended Action Contact Customer Support.
Explanation The requested control block was not in storage.
Recommended Action Contact Customer Support.
Explanation A sub-parameter error was detected by module.
Recommended Action Contact Customer Support.
Explanation The control block at the specified address was invalid.
Recommended Action Contact Customer Support.
Explanation Control block block1's pointer to block2 is zero
Recommended Action Contact Customer Support.
Explanation A module was invoked to format a control block and returned with a return code out of range.
Recommended Action Contact Customer Support.
Explanation A search of the program table for a specific module was made but the end of table occurred without finding the module. The module cannot be loaded because its entry cannot be recorded in the program table.
Recommended Action Contact Customer Support.
Explanation An error occurred from a LOAD macro.
Recommended Action Make sure the LINK library is either in the STEPLIB or Link-List.
Explanation An error from IKJPARS occurred while parsing the options passed via ((options)).
Recommended Action Make sure all the options are valid.
Explanation The group_id is too long, the filter data is too long, or extraneous data after the filter specification was entered.
Recommended Action Verify that the (group_id,'filter') specification is correct.
Explanation A group_id was entered that is invalid.
Recommended Action See the Cisco IOS for S/390 System Management Guide for valid names.
Explanation More trace segments are present than are allowed.
Recommended Action Contact Customer Support.
Explanation An error occurred trying to load module.
Recommended Action Make sure the LINK library is in either the STEPLIB or Link-List.
Explanation An error occurred trying to obtain storage.
Recommended Action Inspect the REGION size for TSO.
Explanation Error errnum occurred executing the filter program.
Recommended Action Contact Customer Support.
Explanation An error occurred generating the filter. func is either STOR or PARS for STORAGE or IKJPARS respectively.
Recommended Action If func is PARS, make sure the filter parameters are valid.
Explanation An error occurred trying to obtain storage.
Recommended Action Inspect the REGION size for TSO.
Explanation An unknown trace segment was encountered.
Recommended Action Contact Customer Support.
Explanation A segment was found that extended beyond the buffer.
Recommended Action Contact Customer Support.
Explanation An unknown component trace entry was encountered.
Recommended Action Contact Customer Support.
|
|