|
|
This chapter describes the function and displays the syntax for the commands required to configure global dialer lists required for preparing the router to bridge or route over a dial-on-demand link. For more information about defaults and usage guidelines, see the corresponding chapter of the Dial Solutions Command Reference.
To define a DDR dialer list to control dialing by protocol or by a combination of a protocol and a previously defined access list, use the dialer-list protocol global configuration command. To delete a dialer list, use the no form of this command.
dialer-list dialer-group protocol protocol-name {permit | deny | list access-list-number |
dialer-group | Number of a dialer access group identified in any dialer-group interface configuration command. |
protocol-name | One of the following protocol keywords: appletalk, bridge, clns, clns_es, clns_is, decnet, decnet_router-L1, decnet_router-L2, decnet_node, ip, ipx, vines, or xns. |
permit | Permits access to an entire protocol. |
deny | Denies access to an entire protocol. |
list | Specifies that an access list will be used for defining a granularity finer than an entire protocol. |
access-list-number | Access list numbers specified in any DECnet, Banyan |
access-group | Filter list name used in the clns filter-set and clns access-group commands. |
Posted: Mon Feb 8 13:51:43 PST 1999
Copyright 1989-1999©Cisco Systems Inc.