AO/DI Commands

This chapter describes the function and displays the syntax for basic commands that can be used to configuring an ISDN D channel to transport X.25 traffic using Always On/Dynamic (AO/DI) ISDN. For more information about defaults and usage guidelines, see the corresponding chapter of the Dial Solutions Command Reference.

ppp bap number

To specify a local telephone number that peers can dial to establish a multilink bundle, use the ppp bap number interface configuration command. To remove a previously configured number, use the no form of this command.

default phone-number	Primary (base) phone number for the interface and the number that can be used for incoming dial calls.
prefix prefix number	Prefix number for the PPP BAP phone number.
format national \| subscriber	Format for the primary phone number to be dialed should be either national or subscriber where the number of digits assigned to the number is as follows: · 10-digit number for a national format. · 7-digit number for a subscriber format.
secondary phone-number	Telephone number for the second B channel. Applies only to BRI interfaces that have a different number for each B channel or to dialer interfaces that are BRIs.

ppp bap number {default phone-number | secondary phone-number | prefix prefix-number}
no ppp bap number {default phone-number | secondary phone-number | prefix prefix-number}
ppp bap number {format national | subscriber}
no ppp bap number {format national | subscriber}

default phone-number

Primary (base) phone number for the interface and the number that can be used for incoming dial calls.

prefix prefix number

Prefix number for the PPP BAP phone number.

format national | subscriber

Format for the primary phone number to be dialed should be either national or subscriber where the number of digits assigned to the number is as follows:

· 10-digit number for a national format.

· 7-digit number for a subscriber format.

secondary phone-number

Telephone number for the second B channel. Applies only to BRI interfaces that have a different number for each B channel or to dialer interfaces that are BRIs.

ppp multilink idle-link

To configure the PPP Multilink bundle so that the first link member enters into "receive-only" mode when an additional B channel is added, use the ppp multilink idle-link interface configuration command. To remove this functionality, use the no form of this command.

ppp multilink idle-link
no ppp multilink idle-link

x25 aodi

To enable the AO/DI client on an interface, use the x25 aodi interface configuration command. To remove AO/DI client functionality, use the no form of this command.

x25 aodi
no x25 aodi

x25 map ppp

To enable a PPP session over the X.25 protocol, use the x25 map ppp interface configuration command. To remove a prior mapping, use the no form of this command.

x121 address	The X.121 address as follows: · Client side---The calling number. · Server side---The called number.
interface	The interface to be used for cloning the configuration.
no-outgoing	Ensures that the X.25 map does not originate calls.

x25 map ppp x121-address interface cloning-interface no-outgoing
no x25 map ppp x121-address interface cloning-interface no-outgoing

x121 address

The X.121 address as follows:

· Client side---The calling number.

· Server side---The called number.

interface

The interface to be used for cloning the configuration.

no-outgoing

Ensures that the X.25 map does not originate calls.

Table of Contents

AO/DI Commands

AO/DI Commands

ppp bap number

ppp multilink idle-link

x25 aodi

x25 map ppp