|
|
This feature extends support for dial-peer digit forwarding to ISDN PRI QSIG signaling calls on the Cisco MC3810.
When ISDN PRI QSIG Signaling was first introduced on the Cisco MC3810 in Cisco IOS Release 12.0(2)T, digit forwarding on POTS dial peers was not supported in conjunction with ISDN PRI QSIG. In this release, digit forwarding is now supported in conjunction with ISDN PRI QSIG.
This feature is supported only on the Cisco MC3810.
ISDN PRI QSIG signaling must be configured.
None.
This procedure configures digit forwarding on the POTS dial peer. It assumes that the destination pattern and the port commands have already been assigned to the POTS dial peer. Digit forwarding is optional on the POTS dial peer.
To configure digit forwarding on the POTS dial peer, use the following commands:
| Step | Command | Purpose | ||
|---|---|---|---|---|
| Router(config)#dial peer voice number pots | Enter dial peer configuration mode for the POTS dial peer. | ||
| Router(config-dialpeer)#forward digits
{num-digits | all | implicit}
| If using the forward-digits feature, configure the digit-forwarding method that will be used on the dial peer. The valid range for the number of digits forwarded (num-digit) is 0-32. If you set the number of digits forwarded to 0, no digits are forwarded. |
If you have relatively few dial peers configured, you can use the show dial-peer voice summary command to verify that the data configured is correct.
The following example configures forward digits for a POTS dial peer on a Cisco MC3810:
dial-peer voice 1 pots
destination-pattern 8...
forward-digits all
This section documents a modified command. All other commands used with this feature are documented in the Cisco IOS Release 12.0 and 12.0(2)T command references.
num-digit | The number of digits to be forwarded. If the number of digits is longer than the length of a destination phone number, the length of the destination number is used. The valid range is 0-32. Setting the value to 0 is equivalent to entering no forward digits (the default). |
all | Forward all digits. If "all" is used, the full length of the destination pattern will be used. |
implicit | Exactly matched digits are not forwarded. Only digits matched by the wildcard pattern are forwarded. |
No digits are forwarded.
Dial-peer configuration
| Release | Modification |
|---|---|
11.3(1)MA | This command was first introduced. |
12.0(2)T | The implicit option was added. |
12.0(4)T | This command was modified to support ISDN PRI QSIG signalling calls. |
This command applies only to the Cisco MC3810.
This command applies only to POTS dial peers.
Forwarded digits are always right-justified so that extra leading digits are stripped.
For QSIG ISDN connections, entering forward-digits all implies that all of the digits of the called party number are sent to the ISDN connection. When you enter forward-digits num-digit and enter a number between 1 and 32, the number of digits specified (right justified) of the called part number are sent to the ISDN connection. When you enter forward-digits implicit, then the number of matched digits matching the wildcard for the called party number are sent to the ISDN connection. For example, if the called part number is 51234, the digits being sent to the ISDN connection is 1234.
The following example configures forward digits for a POTS dial peer on a Cisco MC3810:
dial-peer voice 1 pots
destination-pattern 8...
forward-digits all
| Command | Description |
destination pattern | Defines the prefix or the full E.164 telephone number (depending on your dial plan) to be used for a dial peer. |
Posted: Mon Apr 12 14:13:45 PDT 1999
Copyright 1989-1999©Cisco Systems Inc.