ILMI (Global)

The ILMI (Global) category allows you to access the Interim Local Management Interface (ILMI). The following subcategories are available:

• Switch ATM Address

• LECS Address (Global)

• Default Access Filter

• Access Filter on Interface

When the ILMI (Global) category is selected, the default window displayed is the Switch ATM Address window.

Switch ATM Address

If you select the ILMI (Global) category, the Switch ATM Address window opens. The Switch ATM Address window (Figure 6-42) displays the ATM address information for the switch.

The action buttons are as follows:

• Create--To create a new traffic descriptor, click Create and assign values to the fields. After values are entered, click Apply to commit to set configuration to the switch. (See "Hint for Creating/Modifying a Switch ATM Address Entry" for more information.)

• Modify--To modify the current configuration, edit the field(s) and click Modify to commit the modification. If an invalid value is entered, an error message opens. (See "Hint for Creating/Modifying a Switch ATM Address Entry" for more information.)

Figure 6-42:

Switch ATM Address

Hint for Creating/Modifying a Switch ATM Address Entry

When entering the ATM address for this switch, the address must be entered as either as   13-octet network prefixes (such as 47:00:91:81:00:0b:00:34:76:00:00:23:00) or 20-byte NSAP addresses.

LECS Address (Global)

If you select the LECS Address (Global) category, the LECS Address (Global) window opens. The LECS Address (Global) window (Figure 6-43) displays the entries in the LECS Address table for the device. To create a new traffic descriptor, click Create and assign values to the fields. After values are entered, click Apply to commit to set configuration to the switch. (See "Hint for Creating a LECS Address (Global) Entry" for more information.)

Figure 6-43:

LECS Address (Global)

Hint for Creating a LECS Address (Global) Entry

When setting the ILMI Service Registry Port value, if set to 0, this row applies to all unassigned UNIs.

Default Access Filter

If you select the Default Access Filter category, the Default Access Filter window opens. The Default Access Filter window (Figure 6-44) defines permission access. To modify the current configuration, edit the field(s) and click Modify to commit the modification. If an invalid value is entered, an error message opens.

Figure 6-44:

Default Access Filter

Access Filter on Interface

If you select the Access Filter on Interface category, the Access Filter on Interface window opens. The Access Filter on Interface window (Figure 6-45) allows you to view or modify the current configuration. To modify the current configuration, edit the field(s) and click Modify to commit the modification. If an invalid value is entered, an error message opens.

Figure 6-45:

Access Filter on Interface

Managing ATM Port Features

The ATM port features allow access to the following categories:

• Resource Management (Interface)

• VCC Setup

• VPC Setup

• ATM Signaling (Interface)

• PNNI (Interface)

• ILMI (Interface)

To start the ATM port Feature application, click the left mouse on an ATM port, then select ATM Features.

Only one category is displayed at a time. Change the category to access different management features.

To display the information for any category, select the appropriate category from the pull-down menu by the side of the CATEGORY label.

---

Note Where windows display "optional" fields, you can either enter a value or leave the field blank so the device automatically generates the value.

---

---

Note For additional information regarding the fields within the windows, click Help to access the CiscoView Help screens.

---