Compliance Specifications

Standards Compliance Spe cifications

Table A-1 lists the standards compliance specifications for the Catalyst 6000 family supervisor engine when installed in a system.

Table A-1: Standards Compliance Specifications

Specification Description

Compliance

CE¹ Marking

Safety

UL² 1950, CSA³-C22.2 No. 950, EN⁴60950, IEC⁵ 950, TS⁶ 001, AS/NZS⁷ 3260

EMI⁸

FCC⁹ Class A (47 CFR¹⁰, Part 15), ICES¹¹-003 Class A, EN55022 Class A, CISPR22 Class A, AS/NZS 3548 Class A, and VCCI¹² Class A with UTP¹³ cables

EN55022 Class B, CISPR22 Class B, AS/NZS 3548 Class B, and VCCI Class B (Japan) with FTP¹⁴ cables

¹CE = European Compliance
²UL = Underwriters Laboratories
³CSA = Canadian Standards Association
⁴EN = European Norm
⁵IEC = International Electrotechnical Commission
⁶TS = Technical Specification
⁷AS/NZS = Australia/New Zealand Standards
⁸EMI = electromagnetic interference
⁹FCC = Federal Communications Commission
¹⁰CFR = Code of Federal Regulations
¹¹ICES = Interference-Causing Equipment Standard
¹²VCCI = Voluntary Control Council for Information Technology Equipment
¹³unshielded twisted-pair
¹⁴foil twisted-pair

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to correct the interference at their own expense.

You can determine whether your equipment is causing interference by turning it off. If the interference stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment causes interference to radio or television reception, try to correct the interference by using one or more of the following measures:

Turn the television or radio antenna until the interference stops.
Move the equipment to one side or the other of the television or radio.
Move the equipment farther away from the television or radio.
Plug the equipment into an outlet that is on a different circuit from the television or radio. (That is, make certain the equipment and the television or radio are on circuits controlled by different circuit breakers or fuses.)

Modifications to this product not authorized by Cisco Systems could void the FCC approval and negate your authority to operate this product.

Table of Contents