Default Configurations

Console port

The console port is configured as follows: 9600 baud, 8 data bits, no parity, 1 stop bit.

Passwords

There is no default password for normal and privileged modes. Press Return at the Enter Password prompt.

System prompt

Console>

In-band (sc0) interface configuration

The in-band interface is in VLAN 1; the IP address, subnet mask, and broadcast address are set to 0.0.0.0.

Default gateway

Default gateway address is 0.0.0.0 with a metric of 0.

Port enable state

All ports are enabled

Port name

None

Port duplex setting

Auto (to autonegotiate duplex mode) on Ethernet and Fast Ethernet; full duplex on Gigabit Ethernet (half duplex is not supported)

Port speed (on 10/100-Mbps ports)

Auto (to autonegotiate both speed and duplex)

Spanning-Tree Protocol

Enabled for VLAN 1

Spanning-tree port-VLAN cost

19 for Ethernet and Fast Ethernet ports, 4 for Gigabit Ethernet ports

Spanning-tree port-VLAN priority

32

VLAN

All ports are on VLAN 1

EtherChannel

Disabled

Flow control on Gigabit Ethernet ports

Flow control send is set to desired; flow control receive is set to off

Flow control on other Ethernet ports

Flow control receive is set to off; send is not supported

VTP

Disabled (switch is in a no-management domain state)

VTP version 2

Disabled

VTP domain name

Not specified

VTP mode

Server

VTP pruning

Disabled

VTP password

None (management domains are set to nonsecure mode)

Native VLAN

VLAN 1

MTU size¹

1500 bytes

Pruning eligibility

VLANs 2-1000 are pruning-eligible

VLAN SAID² value

100,000 plus the VLAN number. The SAID for VLAN 1 is 100001, for VLAN 2 100002, for VLAN 3 100003, and so on.

Trunking state

Disabled

Encapsulation

Negotiate (if both ports are set to negotiate mode, the trunk uses ISL encapsulation)

Trunk mode

Auto

Allowed VLANs

All VLANs are allowed for trunking