|
|
This chapter describes how to configure the Route Switch Module (RSM), which provides routing support for the Catalyst 5000 series switches.
The RSM is a router module based on the Route/Switch Processor 2 (RSP2) that runs Cisco IOS software. For instructions on command syntax and using the command-line interface (CLI), refer to the IOS Configuration publication.
To access an RSM installed in a Catalyst 5000 series switch, enter the session mod_num command at the Console> prompt. The switch responds with the Enter Password prompt. Enter the password for the RSM. The RSM responds with the Router> prompt. At this point, you are in user EXEC command mode, and you have direct access only to the RSM with which you have established a session.
The following example shows how to open a session on an RSM:
Console>session mod_num Console> Enter Password:Router>
For additional detailed hardware installation and software configuration procedures for the RSM, see the Catalyst 5000 Series Switch Route Switch Module Installation and Configuration Note.
For additional information on IOS commands, see the Configuration Fundamentals Command Reference publication. For additional information on the Catalyst 5000 series switch commands, including the RSM commands, see the Catalyst 5000 Series Command Reference publication.
The RSM has an optional VIP2 module that allows the RSM to emulate a 7500 series router. For more information on installing and configuring the VIP2 module, see the Catalyst 5000 Series VIP2-15 and VIP2-40 Installation and Configuration Note.
|
|