Component Specifications

Route processor capacity

40-Gbps shared memory, nonblocking switch fabric
up to 32-KB frames

Dimensions (H x W x D)

Modules: 1.2 x 14.4 x 16 in. (3.05 x 36.6 x 40.6 cm)
Port adapter: 1.2 x 6.5 x 10 in. (3.05 x 16.5 x 25.4 cm)
Chassis: 25 x 17.75 x 19.75 in.
(63.5 x 45.09 x 50.17 cm)

Weight

Processor: 6.85 lb (3.11 kg)
Modules: 3.55 lb (1.61 kg)
Chassis: 70 lb (31.75 kg)

Maximum dissipated power at -48VDC¹

Chassis: 1A²

Power supply, DC: 1/2A

Route processor: 2A

Switch processor: 3A

Two-port Gigabit Ethernet Interface Module: 2A

Two-port enhanced Gigabit Ethernet interface module: 2A

Eight-port Gigabit Ethernet interface module: 3A

10/100BaseT interface module: 2A

100BaseFX interface module: 2A

Packet-over-SONET uplink with enhanced Gigabit Ethernet interface module: 2A

ATM uplink with enhanced Gigabit Ethernet interface module: 1.7A

DC voltages supplied and steady-state maximum current ratings

System: +5V³ @ 1.8A
              +12V @ 2A
              +3.3V @ 4A

Operating temperature

32 to 104ºF (0 to 40ºC)

Nonoperating temperature

-40 to 167ºF (-40 to 75ºC)

Humidity

10 to 90%, noncondensing

Altitude

-500 to 10,000 ft (-152 to 3048 m)

Microprocessor

100-MHz MIP⁴ R4700

Memory

16-MB Flash memory SIMM⁵ (upgradable to 16 MB)
256-MB DRAM⁶
256K boot EPROM⁷
128K SRAM⁸
No Flash PC Card installed by default (accepts
8-, 16-, or 20-MB Intel Series 2+ Flash PC Cards)

Management access

Standard Ethernet and EIA/TIA-232 serial port on the route processor

Interface ports

RJ-45 IEEE 802.3 Ethernet 10BaseT port
DB-25 console port for an administration workstation

Interface modules

8 Gigabit Ethernet ports (multimode or
single-mode fiber); 64K
2 Gigabit Ethernet ports (multimode or
single-mode fiber); 16K or 64K
2 Enhanced Gigabit Ethernet ports (multimode or single-mode fiber); 16K, 64K, or 256K
16 10/100BaseT Ethernet ports (RJ-45), 16K or 64K
16 100BaseFX Ethernet ports (multimode fiber); 16K or 64K
1 ATM OC-3c uplink port (multimode or
single-mode fiber); 64K
1 ATM OC-12c uplink port (multimode or
single-mode fiber); 64K or 256K
1 Packet-over-SONET OC-12c uplink port (single-mode fiber); 64K

Network management

Port Tx⁹, Rx¹⁰, and link LEDs
Switch and common equipment status LEDs
Uplink interface Opt-Det, Alarm, and C\D LEDs
Multiple standard and Enterprise MIBs
Text-based command-line interface based on familiar router interface
Standard Cisco IOS security capabilities: password and TACACS
Telnet, TFTP, BOOTP¹¹

MIBs

SNMP¹² MIB II (RFC 1213)
Interface table MIB (RFC 1573)
CISCO-CDP-MIB
CISCO-BRIDGE-MIB

Maximum station-to-station cabling distance

UTP¹³ cable: 328 ft (100 m) with four or fewer separate cable segments on the path; 50/125-micron and 62.5/125-micron multimode fiber: 1640 ft (500 m)

Fiber-optic power levels: Transmit Receive

1261 to 1360 nm¹⁴
Minimum: -15.0 dBm¹⁵
Maximum: -8.0 dBm
Minimum: -28.0 dBm
Maximum: -8.0 dBm

Compliance:

CE Marking (European Union)

Safety

UL¹⁶ 1950, CSA¹⁷-C22.2 No. 950, EN¹⁸ 60950, IEC¹⁹ 60950, TS²⁰ 001, AS/NZS²¹ 3260 IEC 60825, EN 60825, 21CFR²² 1040

EMI

FCC²³ Part 15 Class A (CFR 47 , Part 15),
CISPR 22 Class A, EN 55022 Class A,
VCCI²⁴ Class A, and AS/NZS 3548 Class A
with UTP cables; EN 55022 Class B,
CISPR 22 Class B, VCCI Class B, and AS/NZS 3548, Class B with FTP cables²⁵