|
|
This document contains a summary of the new and changed features for the Catalyst 8540 CSR switch router for Cisco IOS Release 12.0(10)W5(18).
Table 1 lists the new and changed features in the Catalyst 8540 Chassis Installation Guide
| Feature | Description | Chapter or Section |
|---|---|---|
Redundancy | The Catalyst 8540 chassis supports fault tolerance by allowing a secondary (or redundant) route processor and switch module to take over if the primary route processor or primary switch module fails. | Chapter 1, "Product Overview," in the "Route Processors" section on page 1-3 and the "Switch Modules" section on page 1-3. |
Table 2 lists the new and changed features in the Catalyst 8540 CSR Route Processor and Interface Module Installation Guide
| Feature | Description | Chapter or Section |
|---|---|---|
Two-port enhanced Gigabit Ethernet interface module | Two one-port enhanced Gigabit Ethernet port adapters with built-in ACL functionality and 16, 64, or 256 KB of memory available for routing tables | "Component Overview," in the "Two-Port Enhanced Gigabit Ethernet Interface Module" section on page 1-11 "Checking the Installation," in the "Two-Port Enhanced Gigabit Ethernet Interface Module LEDs" section on page 4-8 |
ATM uplink with enhanced Gigabit Ethernet interface module | A one-port ATM OC-3c or OC-12c uplink port adapter with built-in ACL functionality and a one-port enhanced Gigabit Ethernet port adapter | "Component Overview," in the "ATM Uplink with Enhanced Gigabit Ethernet Interface Module" section on page 1-14 Chapter 4, "Checking the Installation," in the "ATM Uplink with Enhanced Gigabit Ethernet Interface Module" section on page 4-10 |
Packet-over-SONET uplink with enhanced Gigabit Ethernet interface module | A one-port packet-over-SONET OC-12c uplink port adapter with built-in ACL functionality and a one-port enhanced Gigabit Ethernet port adapter | "Component Overview," in the "Packet-over-SONET Uplink with Enhanced Gigabit Ethernet Interface Module" section on page 1-15 "Checking the Component Installation," in the "Packet-over-SONET Uplink with Enhanced Gigabit Ethernet Interface Module" section on page 4-12 |
Table 3 lists the new and changed features in the Layer 3 Software Feature and Configuration Guide :
| Feature | Description | Chapter or Section |
|---|---|---|
Access control lists | Built-in support for ACLs on enhanced Gigabit Ethernet interfaces | " Access Control Lists" section in "Overview of Layer 3 Switching and Software Features" |
Load balancing | Up to six equal-cost paths for IP and IPX; per-packet load balancing for IPX | " Load Balancing" section in "Overview of Layer 3 Switching and Software Features" and "Configuring Networking Protocols" |
.
![]()
![]()
![]()
![]()
![]()
![]()
![]()
Posted: Tue Sep 26 15:14:59 PDT 2000
Copyright 1989-2000©Cisco Systems Inc.