|
|
This chapter lists configuration requirements and describes how to install the Cisco IP/VC Configuration Utility software.
The computer on which you are installing the configuration utility must have the following:
This section describes how to install and start the IP/VC Configuration Utililty software. This software allows you to configure all IP/VC 3500 Series hardware including the IP/VC 3510 MCU, the IP/VC 3520 and IP/VC 3525 Gateways, and the IP/VC 3530 VTA.
You must install the IP/VC Configuration on a computer running Microsoft Windows or the Windows NT operating system.
The IP/VC 3500 CD-ROM setup installs the IP/VC configuration software on your hard drive. The CD-ROM contains the following:
To install the IP/VC 3500 software, perform the following steps:
Step 1 Start Windows or Window NT on the computer on which you want to install the configuration utility.
Step 2 Insert the IP/VC 3500 CD-ROM into the CD-ROM drive on the computer (usually drive D:).
If your CD-ROM drive is configured with Auto Insert Notification enabled, the Cisco IP/VC Installer window appears automatically.
If you do not have Auto Insert Notification enabled, click Start>Run and enter D:\setup (assuming D: is your CD -ROM drive) on the Run dialog box. After a few moments the Setup program displays the Cisco IP/TV Installer window.
Step 3 Follow the installation setup program instructions.
You can access the configuration software sequential windows by clicking the Next and Prev buttons. Some windows also have secondary windows that are accessed through buttons. These are identified by the name of the window they invoke, for example, the Date/Time Settings window is a secondary window of the Unit Identification window and can be accessed from the Date/Time button on this screen.
Table 4-1 describes the configuration software navigation buttons.
| Button | Shortcut Key | Action |
Abort | Alt-A | Exits the Configuration program without saving your changes. |
Next | Alt-N | Moves to a subsequent screen, saving any changes you made. |
Prev | Alt-P | Moves to a previous screen. If you exit a dialog box using Prev, changes you make to the information in the dialog box are saved. |
Finish | Alt-F | Allows you to save the configuration settings in a file and upload these settings to the VTA. |
Detect | Alt-D | Sends a broadcast message to the network, requesting identification from any units that have not yet identified themselves. |
Save | Alt-S | Saves parameter values of the dialog box to the local disk as a text file in the directory where you installed the Configuration Software. |
OK | --- | Saves the information and exits the dialog box. The saved tables contain only static data that is both readable and writeable. |
Cancel | --- | Returns to the previous dialog box without saving any changes you made to the current dialog box. |
| In a Confirmation box | ||
Yes | Alt-Y | Saves the parameters and proceeds to the next screen. |
No | Alt-N | Returns to the previous screen. |
Posted: Fri Nov 12 19:47:17 PST 1999
Copyright 1989-1999©Cisco Systems Inc.