Table of Contents
INDEX
- 100 Mbps light 2 - 3
- AC power supply 1 - 5, 2 - 15, 6 - 1, 7 - 1
- accessory kit 2 - 1
- AccessPro router 7 - 6
- ACT light 2 - 3
- activation key 2 - 10, 2 - 16
- Active unit indicator light 2 - 3
- amps 8 - 2, 8 - 3
- AT29C040A 2 - 16
- back cover plate 7 - 4
- battery replacement 5 - 6
- board, adding 7 - 5
- boot image 2 - 7
- cable, failover 3 - 4
- cable, serial 2 - 5
- Canadian Electrical Code 1 - 5
- circuit breaker for DC unit 1 - 5
- Cisco warranty 1 - 4
- clear flashfs command 2 - 7
- console port 2 - 3
- cover 2 - 7
- cover plate 7 - 4
- cover, top 5 - 1
- CSA 22.2-950 8 - 1
- DB-9 connector and DB-25 connector 2 - 5
- DC power supply 1 - 5, 8 - 1
- DC voltage PIX 515 8 - 1
- DIMM strip 6 - 5
- disconnect the power 1 - 4
- disk_empty_watch_timer 4 - 3
- disk_full_watch_timer 4 - 3
- download configuration 2 - 7
- electrostatic discharge (ESD) 1 - 5
- empty slot 2 - 12
- EN60950 and EN41003 8 - 1
- encryption device 2 - 18
- equipment rack 1 - 7, 2 - 6, 2 - 11
- Ethernet 7 - 1
- ETHERNET 1 and ETHERNET 0 2 - 4
- failover 2 - 1, 2 - 3, 3 - 1
- fan, ventilation 1 - 7
- FDDI 1 - 2, 1 - 3, 7 - 1
- FDDI card cable 7 - 8
- FDX light 2 - 3
- feet, rubber, attaching 2 - 5
- Flash memory 1 - 1, 1 - 2, 2 - 7, 2 - 16
- four-port interface 2 - 4, 2 - 12, 2 - 13, 7 - 3
- frequently asked failover questions 3 - 4
- grounding lug 8 - 1
- grounding strap 6 - 4
- hardware requirements 1 - 1
- HyperTerminal 2 - 8
- indicator lights 2 - 3
- inserting a new board 7 - 5
- inside interface 2 - 2, 2 - 4, 2 - 12
- install a PIX Firewall 2 - 1
- install floppy version onto Flash memory 2 - 16
- installing the PIX Firewall 1 - 1
- insufficient memory 2 - 17
- interface card 7 - 1
- interfaces, maximum 1 - 1, 1 - 2
- International Electrotechnical Commission (IEC) 1 - 5
- IRQ (interrupt request lines) 2 - 17
- leaks, radio 5 - 1
- LEDs 2 - 3
- lights 2 - 3
- LINK light 2 - 3
- lithium battery replacement 5 - 6
- log files, syslog 4 - 1
- monitor mode 2 - 7
- National Electric Code ANSI/ NFPA 1 - 5, 8 - 1
- National Fire Protection Association (NFPA) 1 - 5
- NETWORK light 2 - 3
- NTFS partition 4 - 1
- opening top panel 5 - 1, 5 - 5
- outside interface 2 - 2, 2 - 4, 2 - 12
- panel, removing
- early PIX Firewalls 5 - 3
- PIX 515 5 - 2
- PIX10000 5 - 4
- PCI slot 1 - 2
- PFSS 4 - 1
- pfss.log file 4 - 1
- pinouts, failover 3 - 4
- PIX 515 5 - 1
- activation key 2 - 10
- controls and connectors 2 - 3
- DIMM memory location 6 - 2
- inserting a board 7 - 2
- installing 2 - 3
- PIX 515, DC 8 - 1
- PIX 520 5 - 5
- controls and connectors 2 - 11
- diskette access 2 - 11
- installation 2 - 11
- memory location 6 - 4
- PIX Firewall controls 2 - 12
- PIX Firewall Manager 9 - 1
- PIX Firewall Syslog Server (PFSS) 4 - 1
- PIX10000
- memory location 6 - 3
- opening and closing unit 5 - 4
- PIX-515-R license 2 - 7
- PIX-515-UR license 2 - 4
- ports for syslog server 4 - 3
- power cord 2 - 1
- POWER light 2 - 3
- power supply
- AC and DC 1 - 5
- considerations 1 - 6
- Private Link 1 - 2, 1 - 3, 2 - 17, 7 - 1, 7 - 6
- radio frequency leaks 5 - 1
- RAM 2 - 17, 6 - 2, 6 - 10
- requirements 1 - 1
- router in PIX Firewall 7 - 6
- rubber feet, attaching 2 - 5
- safety 1 - 4
- safety extra low voltage (SELV) requirements 1 - 5, 8 - 1
- serial cable 2 - 5, 2 - 14
- Services menu commands 4 - 3
- Setup Wizard 9 - 1
- show version command 6 - 10
- SIMM strip 6 - 5
- site environment 1 - 5
- slots 2 - 12
- software requirements 1 - 1
- Standby mode indicator light 2 - 3
- startup messages 2 - 15
- Stateful Failover dedicate interface 3 - 2
- syslog server 4 - 1
- TCP syslog 4 - 1
- TFTP server, download configuration 2 - 7
- Token Ring 7 - 1
- top cover 2 - 7, 5 - 1
- UL 1950 8 - 1
- USB port 2 - 3
- ventilation fan 1 - 7
- warranty 1 - 4
- wire 8 - 1
- wrist strap 6 - 4
- Writing image into Flash memory 2 - 17







Posted: Thu Oct 21 14:59:56 PDT 1999
Copyright 1989-1999©Cisco Systems Inc.