P Commands for Cisco DSLAMs with NI-2

payload-scrambling

To enable ATM cell payload scrambling on a DMT subscriber port, use the payload-scrambling profile configuration command. To disable payload scrambling, use the no form of the command.

payload-scrambling

no payload-scrambling

Syntax Description

This command has no keywords or arguments.

Default

Enabled

Command Mode

Profile configuration

Command History

Release
Modification

12.1(1)DA

This command was introduced.

Release	Modification
12.1(1)DA	This command was introduced.

Usage Guidelines

The two ends of a connection must have the same payload scrambling value—that is, payload scrambling must be enabled at both ends or disabled at both ends. The line does not train if payload scrambling is enabled at one end and disabled at the other end.

Enabling or disabling payload scrambling does not untrain or retrain a port.

Example

This command disables payload scrambling for the default DSL profile:

DSLAM# configure terminal
DSLAM(config)# dsl-profile default
DSLAM(cfg-dsl-prof)# no payload-scrambling

Related Commands

show dsl profile

show dsl interface atm slot#/port#

Table of Contents