Line (LIM Port) Events

This chapter explains how to diagnose and handle line (LIM port) events that are generated by the Cisco 6100 Series system. The following information is presented for each of the events:

Event summary---A summary of the event information including the ID, event name, and its severity.
Description---A short description of the event. Appears in the ViewRunner for Windows Event History View dialog box or the ViewRunner for HP OpenView Error Events Browser.
Impact---A short discussion of the probable impact of the event. It lists, for example, the number of subscribers who could be affected by this problem.
Action---A step-by-step procedure for handling the event described in the section.

If none of the actions presented for the event are successful, contact the Cisco Technical Assistance Center (TAC) for additional support.

Note Refer to the ViewRunner for Windows User Guide or the ViewRunner for HP OpenView User Guide for detailed information on viewing events in the ViewRunner management software. Refer to "Event Guidelines and Definitions" for detailed information on event severity guidelines and alarm event status changes.

Table 13-1 lists line (LIM port) events and their IDs, definition, severity, and description. A detailed explanation of these events and the corrective actions that are required (if any) is located in this chapter.

Table 13-1: Line (LIM Port) Events

ID Definition Severity Description

1

CCNX_OLD_CPE_DETECT

Major

Improper version signature on CPE modem

2

LINE_LOCKOUT

Minor

Line disconnected due to session length

3

LINE_IDLE_TIMEOUT

Info

Line disconnected due to inactivity

ID	Definition	Severity	Description
1	CCNX_OLD_CPE_DETECT	Major	Improper version signature on CPE modem
2	LINE_LOCKOUT	Minor	Line disconnected due to session length
3	LINE_IDLE_TIMEOUT	Info	Line disconnected due to inactivity

Note Events with an ID less than 128 are specific to the module in alarm. Events with an ID value greater than or equal to 128 are system-wide events.

Improper Version Signature on CPE Modem

Event Summary

ID	Event Name	Severity
1	CCNX_OLD_CPE_DETECT	Major

Description

The following description appears in the ViewRunner for Windows Event History View dialog box or the ViewRunner for HP OpenView Error Events Browser:

Improper version signature on CPE modem

Impact

The CPE detection feature is used to discover CPE gear that is not capable of performing Idle or Session timeouts. During training, the CPE detection feature determines if the CPE equipment can be timer enabled. If the equipment can be timer enabled, training will continue. If the equipment cannot be timer enabled, an alarm is generated in ViewRunner and training will not be successful until the Cisco 600 Series CPE device is updated to at least version 2.0.1. The line port or modem port will not train successfully until the Cisco 600 Series CPE device is updated to at least version 2.0.1.

Action

Either lower the CPE detect/reject feature to zero or upgrade the CPE to at least version 2.1.0.

Line Disconnected Due to Session Length

Event Summary

ID	Event Name	Severity
2	LINE_LOCKOUT	Minor

ID	Event Name	Severity
3	LINE_IDLE_TIMEOUT	Info

Table of Contents

Line (LIM Port) Events