Table of Contents
Cisco 675e Specifications
- 5.0 in x 6.2 in x 1.75 in (12.7 cm x 15.7 cm x 4.5 cm)
- RJ-45 connector, 10Base-T/100Base-TX Ethernet, half-duplex, compliant with IEEE 802.3 and 802.3u
- RJ-45 connector
- Baud rate: 9600 to 115200 Kbps
- Data bits: 8
- Parity: none
- Stop bits: 1
- Flow control: none
- RADSL, CAP encoding
- RJ-11 connector
- RJ-11 connector with built-in EZ-DSL microfilter (North American version only)
- Temperature: 32º to 104º F (0º to 40ºC)
- Humidity: 5 to 90% (non-condensing)
- FCC Part 15, 1997---United States Federal Communications Commission Part 15, Subpart B
- CSA Std. C108.8 (1993)---EMC (Industry Canada, Radio Inteference Regulations, Issue 2 1992) Canadian Standard C108.8
- VCCI, 1995---Agreement of Voluntary Control Council for Interference by Information Technology Equipment (VCCI Japan),August 1995
- AS/NZS 3548: 1995---EMI (Australia), Spectrum Management Association
- EN55022: 1994/CISPR 22: 1993---Limits and methods of measurement of radio interference characteristics of information technology equipment.
- EN50081-1:1997---Electromagnetic compatibility---Generic emission standard, Part 1: Residential, commercial and lilght industry
- CNS 13438---EMI Standard (Taiwan) regulated by BCIQ Agency
- UL 1950 3rd Edition/CSA C22.2. No. 950
- VDE per EN60950/IEC950 Amendment 4
- CE Marked for EMC and Safety
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Posted: Thu May 27 13:15:16 PDT 1999
Copyright 1989-1999©Cisco Systems Inc.
