Using Wire Restraints on the Cisco 6400 Universal Access Concentrator

October 27, 1999

This document describes how to use wire restraints to manage NSP and NRP cables on the Cisco 6400 universal access concentrator (UAC). Use this document in conjunction with the Cisco 6400 UAC Hardware Installation and Maintenance Guide.

1. Pull the NSP or NRP cables across the wire restraint and bend the restraint upwards to trap the cables.

2. Route the cables through the cable management bracket, creating a 20 inch (or larger) service loop, as shown in the cable routing diagram on the blower.

IMPORTANT: A minimum 20-inch loop is critical to hot swapping the blower.

Table of Contents

Using Wire Restraints on the Cisco 6400 Universal Access Concentrator

Using Wire Restraints on the Cisco 6400 Universal Access Concentrator