O Command for the LightStream 1010 ATM Switch

outgoing-port

To filter ATM signalling call failure based on the outgoing interface rejected call, use the outgoing-port signalling diagnostic configuration command. To return the outgoing port to the default, use the no form of this command.

outgoing-port [atm card/subcard/port]
no outgoing-port

Syntax Description

card/subcard/port

Specifies the card, subcard, and port of the ATM interface. The card number is displayed using the show interface command.The subcard number can be either 0 or 1.

Default

0

Command Mode

Diagnostics configuration

Usage Guidelines

The default 0 means the incoming interface is not considered during filtering.

Example

The following example shows the outgoing-port command.

Switch# configure terminal
Switch(config)# outgoing-port ATM0/1/1