|
|
The LightStream 1010 ATM switch processor (ASP) specifications are described in Table A-1.
For the LightStream 1010 ATM switch chassis and common equipment specifications, see the appendix "System Chassis Specifications" in the LightStream 1010 ATM Switch Hardware Installation Guide. For port adapter module (PAM) specifications see the appendix "System PAM Specifications" in the LightStream 1010 ATM Switch PAM Installation Guide.
| Description | Specifications |
|---|---|
Switch and Processor Capacity | 5 Gbps shared memory, nonblocking switch fabric |
Software Images | Default image with IISP protocol |
ASP and CM: 1.2 x 14.4 x 16 in. (3.0 x 36.6 x 40.6 cm) | |
6.85 lb (3.09 kg) | |
DC Voltages Supplied and Steady-state Maximum Current Ratings | +5V @ 70A |
32 to 104ºF (0-40ºC) | |
Nonoperating Temperature | -40 to 167ºF (-40-75ºC) |
10-90%, noncondensing | |
Altitude | -500 to 10,000 ft. (-52 to 3048 m) |
100-MHz MIPS R4600 | |
8 MB of Flash memory (upgradable to 16 MB) | |
Interface Timing | Loop timing, Stratum 4 accuracy clock for self-timing, master clock distribution port |
ATM Switch Processor (ASP) | ASP module, 16-MB DRAM, 8-MB Flash memory, no Flash card installed (WATM-ASP1) |
Management Access | Standard Ethernet and dual EIA/TIA 232 serial ports on ASP module |
Connections | 32,000 point-to-point, 2048 multi-to-multipoint |
ASP Interface Ports | RJ-45 IEEE 802.3 Ethernet 10BaseT port |
Network Management | Port TX and RX LEDs, switch and common equipment status LEDs |
Mean Time Between Failures | 2.6 years for system configuration |
Management Information Bases (MIB) | SNMP MIB II (RFC 1213) |
10BaseT Ethernet-Category 3-5 UTP8: 328 ft. (100 m) | |
Safety: UL9 1950, CSA10-C22.2 No. 950, EN60950, IEC95011, TS001 |
|
|