|
|
To filter ATM signalling call failure based on the outgoing interface rejected call, use the outgoing-port signalling diagnostic configuration command. To return the outgoing port to the default, use the no form of this command.
outgoing-port [atm card/subcard/port]
card/subcard/port | Specifies the card, subcard, and port of the ATM interface. The card number is displayed using the show interface command.The subcard number can be either 0 or 1. |
0
Diagnostics configuration
The default 0 means the incoming interface is not considered during filtering.
The following example shows the outgoing-port command.
Switch# configure terminal Switch(config)# outgoing-port ATM0/1/1
Posted: Tue Jun 22 13:38:57 PDT 1999
Copyright 1989-1999©Cisco Systems Inc.