ASP Specifications

The LightStream 1010 ATM switch processor (ASP) specifications are described in Table B-1.

For the LightStream 1010 ATM switch chassis and common equipment specifications, refer to the appendix "System Chassis Specifications" in the LightStream 1010 ATM Switch Hardware Installation Guide. For port adapter module (PAM) specifications, refer to the appendix "CM and PAM Specifications" in the LightStream 1010 ATM Switch PAM Installation Guide.

Table B-1: ASP Specifications
Description Specifications

Switch and processor capacity

5-Gbps shared memory, nonblocking switch fabric
65,536 cells of ATM cell buffers

Dimensions (H x W x D)

ASP: 1.2 x 14.4 x 16 in. (3.0 x 36.6 x 40.6 cm)

Weight

6.85 lb (3.09 kg)

DC voltages supplied and steady-state maximum current ratings

System: +5V @ 70A
              +12V @ 2A
              +24V @ 0.2A
ASP:      +5V @ 15A
              +24V @ 25mA
             +12V @ 500mA

Operating temperature

32 to 104ºF (0 to 40ºC)

Nonoperating temperature

-40 to 167ºF (-40 to 75ºC)

Humidity

10 to 90%, noncondensing

Altitude

-500 to 10,000 ft. (-52 to 3048 m)

Microprocessor

100-MHz MIP¹ R4700

Memory

8-MB Flash memory SIMM (upgradable to 16 MB)
32-MB DRAM² default for FC-PCQ³ (upgradable to 64 MB) and 64-MB DRAM
    default for FC-PFQ⁴
256-KB boot EPROM⁵
128-KB SRAM⁶
No Flash memory (PCMCIA⁷) card installed by default (accepts 8-, 16-, or 20-MB Intel Series 2+ Flash memory cards)

Interface timing

Loop timing, Stratum 4 accuracy clock for self-timing, master clock distribution port

Management access

Standard Ethernet and dual EIA/TIA-232⁸ serial ports on the ASP

Connections

32,000 point-to-point, 2048 multi-to-multipoint
VC⁹ and VP¹⁰ switching, VP tunneling
PVC¹¹ and SVC¹²
F4 and F5 OAM¹³ segment and end-to-end flows, RDI¹⁴ and AIS¹⁵
OAM PING on IP or ATM address

Interface ports

RJ-45 IEEE¹⁶ 802.3 Ethernet 10BaseT port
   DB-25 EIA/TIA-232 auxiliary port and a
   DB-25 console port for an administration workstation

Network management

Port TX¹⁷ and RX¹⁸ LEDs¹⁹, switch and common equipment status LEDs
Port snooping²⁰ and connection steering
Multiple standard and Enterprise MIBs²¹
Text-based command-line interface based on familiar router interface
Standard Cisco IOS security capabilities: password and TACACS,²²
Telnet, TFTP²³, BOOTP, LAN Emulation client, RFC²⁴ 1577 Classical IP over
    ATM client (for management access)

MIBs

SNMP MIB II (RFC 1213)
Interface table MIB (RFC 1573)
AToM MIB (RFC 1695)
ATM Forum PNNI 1.0 MIB
ATM Forum UNI 3.0/3.1 ILMI²⁵ 4.0 MIB

Agency Approvals

UL²⁶ 1950 (U.S.)
CSA²⁷ 950 (Canada)
EN²⁸60950 (European Union)
CE Marking
TUV²⁹ GS (Germany)
IEC³⁰ 950 (International)
AS/NZS³¹ 3260 (Australia/New Zealand)
CE Marking
FCC³² Part 15 (CFR 47) Class A
VCCI³³ Class A with UTP and Class B with shielded cables (Japan)
EN55022 Class A with UTP and Class B with shielded cables (European Union)
CISPR³⁴ 22 Class A with UTP and Class B with shielded cables (International)
AS/NZS 3548 Class A with UTP and class B with shielded cables

¹MIP = MultiChannel Interface Processor.
²DRAM = dynamic random-access memory.
³FC-PCQ = feature card per-class queueing.
⁴FC-PFQ = feature card per-flow queueing.
⁵EPROM = erasable programmable read-only memory.
⁶SRAM = static random-access memory.
⁷PCMCIA = Personal Computer Memory Card International Association.
⁸EIA/TIA = Electronic Industries Association/Telecommunications Industry Association.
⁹VC = virtual channel.
¹⁰VP = virtual path.
¹¹PVC = permanent virtual circuit.
¹²SVC = switched virtual circuit.
¹³OAM = Operations, Administration, and Maintenance.
¹⁴RDI = remote defect identification.
¹⁵AIS = alarm indication signal.
¹⁶IEEE = Institute of Electrical and Electronics Engineers.
¹⁷TX = transmit.
¹⁸RX = receive.
¹⁹LEDs = light emitting diodes.
²⁰FC-PFQ supports per-VC, per-VP, and per-port snooping.
²¹MIBs = Management Information Bases.
²²TACACS = Terminal Access Control Access System.
²³TFTP = Trivial File Transfer Protocol.
²⁴RFC = Request For Comments.
²⁵ILMI = Interim Local Management Interface.
²⁶ UL = Underwriters Laboratory.
²⁷CSA = Canadian Standards Association.
²⁸EN = European Norm.
²⁹TUV = German Test Agency.
³⁰IEC = International Electrotechnical Commission.
³¹AS/NZS Australia/New Zealand Standards.
³²FCC = Federal Communications Commission.
³³VCCI = Voluntary Control Council for Interference.
³⁴CISPR = Comite International Special Des Perturbations Radioelectriques.

Description	Specifications
Switch and processor capacity	5-Gbps shared memory, nonblocking switch fabric 65,536 cells of ATM cell buffers
Dimensions (H x W x D)	ASP: 1.2 x 14.4 x 16 in. (3.0 x 36.6 x 40.6 cm)
Weight	6.85 lb (3.09 kg)
DC voltages supplied and steady-state maximum current ratings	System: +5V @ 70A +12V @ 2A +24V @ 0.2A ASP: +5V @ 15A +24V @ 25mA +12V @ 500mA
Operating temperature	32 to 104ºF (0 to 40ºC)
Nonoperating temperature	-40 to 167ºF (-40 to 75ºC)
Humidity	10 to 90%, noncondensing
Altitude	-500 to 10,000 ft. (-52 to 3048 m)
Microprocessor	100-MHz MIP¹ R4700
Memory	8-MB Flash memory SIMM (upgradable to 16 MB) 32-MB DRAM² default for FC-PCQ³ (upgradable to 64 MB) and 64-MB DRAM default for FC-PFQ⁴ 256-KB boot EPROM⁵ 128-KB SRAM⁶ No Flash memory (PCMCIA⁷) card installed by default (accepts 8-, 16-, or 20-MB Intel Series 2+ Flash memory cards)
Interface timing	Loop timing, Stratum 4 accuracy clock for self-timing, master clock distribution port
Management access	Standard Ethernet and dual EIA/TIA-232⁸ serial ports on the ASP
Connections	32,000 point-to-point, 2048 multi-to-multipoint VC⁹ and VP¹⁰ switching, VP tunneling PVC¹¹ and SVC¹² F4 and F5 OAM¹³ segment and end-to-end flows, RDI¹⁴ and AIS¹⁵ OAM PING on IP or ATM address
Interface ports	RJ-45 IEEE¹⁶ 802.3 Ethernet 10BaseT port DB-25 EIA/TIA-232 auxiliary port and a DB-25 console port for an administration workstation
Network management	Port TX¹⁷ and RX¹⁸ LEDs¹⁹, switch and common equipment status LEDs Port snooping²⁰ and connection steering Multiple standard and Enterprise MIBs²¹ Text-based command-line interface based on familiar router interface Standard Cisco IOS security capabilities: password and TACACS,²² Telnet, TFTP²³, BOOTP, LAN Emulation client, RFC²⁴ 1577 Classical IP over ATM client (for management access)
MIBs	SNMP MIB II (RFC 1213) Interface table MIB (RFC 1573) AToM MIB (RFC 1695) ATM Forum PNNI 1.0 MIB ATM Forum UNI 3.0/3.1 ILMI²⁵ 4.0 MIB
Agency Approvals	UL²⁶ 1950 (U.S.) CSA²⁷ 950 (Canada) EN²⁸60950 (European Union) CE Marking TUV²⁹ GS (Germany) IEC³⁰ 950 (International) AS/NZS³¹ 3260 (Australia/New Zealand) CE Marking FCC³² Part 15 (CFR 47) Class A VCCI³³ Class A with UTP and Class B with shielded cables (Japan) EN55022 Class A with UTP and Class B with shielded cables (European Union) CISPR³⁴ 22 Class A with UTP and Class B with shielded cables (International) AS/NZS 3548 Class A with UTP and class B with shielded cables

Table of Contents

ASP Specifications

ASP Specifications