H Command

Note Commands that are identical to those documented in the Cisco IOS software documentation have been removed from this chapter. Refer to Appendix D, "Removed and Changed Commands," of this command reference for a list of removed commands.

hold-queue

Note This command or some of its parameters might not function as expected.

hw-module

To reset a specific port adapter, use the hw-module EXEC command.

hw-module {slot number | subslot subslot/subcard} reset

Syntax Description

slot number	Physical slot number of the port adapter you want to reset.
subslot subslot or subcard	Indicates either a half-width card or daughter card attached to full width cards. If the subcard is not specified, in the case of a half-width card, both the cards in the slot are reset. In case of full width cards, the motherboard in the slot is reset.
reset	Reset is performed on the hardware module selected using slot or subslot options.

Default

None

Command Mode

EXEC

Usage Guidelines

If the subcard is not provided, both subcards in the slot are reset. In the case of a full width card, the motherboard in the selected slot is reset. The subcard argument indicates a specific subcard in a selected slot. If the subcard is not given, the full width card in the selected slot is reset.

This command is available to reset port adapters only. The hw-module command cannot be used to reset route processor controllers and switch controllers.

Caution
If any active connections are configured on this port, they will be lost until the port adapter restarts. The running configuration is restored only when the port adapter returns to normal operational.

Example

The following example resets the port adapter in slot 3.

Switch# hw-module slot 3 reset

Related Command

reprogram

Table of Contents

H Command

H Command

hold-queue

hw-module

Syntax Description

Default

Command Mode

Usage Guidelines

Example

Related Command