|
|
The show frelay commands are used to display Frame Relay configuration and statistics within the router.
show frelay {config | dlci | pvc [WAN slot:port [dlci]] | stats [WAN slot:port [dlci]]}
config | Shows the status of the Frame Relay configuration for each physical port of the router. This includes whether it is on or off, which local maintenance protocol is configured, and the interval for exchanging the local maintenance packets. |
dlci | Shows the configured DLCI (Data Link Connection Identifier) mappings. These are DLCI's that have been configured with their specific protocol address mappings. |
pvc [WAN slot:port [dlci]] | Shows the status of the PVCs (Permanent Virtual Circuits) that have been picked up from the Frame Relay switch through local maintenance packets. It shows the status of the PVC, the Q.922 physical address and DLCI value for the PVC, the total number of input and output packets, a reference and use count, and the up time of the PVC. If no port number is specified, then the known PVC for all ports will be shown. If a port is specified, then the PVCs for that specific port are shown. If a dlci is specified in conjunction with a port, the status of the PVC will be shown that includes the above data along with an expanded list of packet statistics. This expanded list includes tallies for input and output fragmented packets, FECN and BECN packets and packets that have been discarded. Certain dlci numbers are used for maintenance protocols (i.e., 0 is used for ANSI Annex-D, and 1023 is used for LMI). |
stats [WAN slot:port [dlci]] | Shows an expanded list of Frame Relay packet tallies, described above, for each port of the router. If a port is specified, then only the extended Frame Relay packet tallies for that port are shown. If a dlci is specified in conjunction with a port, then the extended Frame Relay packet tallies for that PVC or DLCI are shown. |
The following sections show an example for each command.
The following is the output from a show frelay config command.
Port Maint Poll MTU DLCI Wan0 annexD 10 1500 n/a Wan1 Off \
The following is the output from a show frelay dlci command.
Wan0 DLCI Configuration DLCI IP AppleTalk IPX DECnet 101 10.1.2.2 Off IARP Off 103 10.1.2.3 Off IARP Off 102 10.1.2.4 Off IARP Off 100 10.1.2.5 Off IARP Off
The following is the output from a show frelay pvc command.
Wan0 Frame Relay PVC DLCI State Type Interface Flags Q.922 Ref Use Active (D:H:M:S) 102 Inactive User ni_wan0 21 1861 1 3018 0:00:00:00 101 Active User ni_wan0 21 1851 3 112944 10:03:49:38 16 Active User ni_wan0 21 0401 667 59709 2:08:22:58 0 Active Maint ni_wan0 41 0001 1 175562 10:03:50:02
| Command | Description |
|---|---|
configure Frame Relay | Configures Frame Relay parameters for an interface |
Posted: Wed Sep 27 11:42:28 PDT 2000
Copyright 1989-2000©Cisco Systems Inc.