|
|
The ospfenable and ospfdisable commands allow the user to temporarily disable or enable the OSPF protocol without restarting the router.
The ospfdisable command will cause the router to notify its neighbors that it is "going down." The ospfenable command will allow the router to re-establish the adjacencies with each neighbor from scratch, just as if the router was first coming up. The ospfenable command should be used only after ospfdisable has been used.
ospfenable
| Command | Description |
|---|---|
configure IP | Configures IP parameters for an interface |
configure IP Route Redistribution | Configures how the concentrator redistrubutes routes from one dynamic IP routing protocol into another. |
configure OSPF Area | Configures OSPF area parameters |
configure OSPF Virtual Link | Configures OSPF to allow an area that is not contiguous to the backbone area (area 0) to operate |
edit config IP Route Filter | Creates IP route filters |
show ospf | Shows OSPF configuration and statistics |
Posted: Wed Sep 27 11:11:20 PDT 2000
Copyright 1989-2000©Cisco Systems Inc.