|
|
The interface command is used to select an interface to configure. Most set commands require an interface to be selected prior to modifying the configuration.
If you are in enabled mode, the command prompt will let you know which interface you are configuring.
interface {{Ethernet | WAN} slot:port | VPN number | Bridge [0.sub-interface]}To select the first Ethernet interface, the next three commands are equivalent.
interface ethernet interface ethernet a interface ethernet 0
To select the Bridge protocol port.
interface bridge
| Command | Description |
|---|---|
enable, disable | Enables or disables privileged commands |
Posted: Wed Sep 27 11:05:17 PDT 2000
Copyright 1989-2000©Cisco Systems Inc.