Miscellaneous Commands

This chapter lists miscellaneous management commands.

apply

The apply command is a privileged command that requires enabled mode to operate. This command allows you to apply a configuration to the device immediately, without restarting the device.

apply [flash]

apply

Applies a configuration immediately without restarting.

If you make a change, the command applies the configuration you just changed, but does not save it to Flash memory. If you restart the system, your changes are lost unless you use the save or write command.

If you make a change and write it to flash memory, the command applies the change from flash memory.

apply flash

flash applies the existing configuration from Flash memory, overwriting your runtime changes.

apply	Applies a configuration immediately without restarting. If you make a change, the command applies the configuration you just changed, but does not save it to Flash memory. If you restart the system, your changes are lost unless you use the save or write command. If you make a change and write it to flash memory, the command applies the change from flash memory.
apply flash	flash applies the existing configuration from Flash memory, overwriting your runtime changes.

Related Commands

Command Description

save

Saves the edited configuration

write

Writes the configuration to Flash memory

Command	Description
save	Saves the edited configuration
write	Writes the configuration to Flash memory

Table of Contents