cc/td/doc/product/aggr/vpn5000/5000sw/conc52x/ref52x
hometocprevnextglossaryfeedbacksearchhelp
PDF

Table of Contents

Add Commands

Add Commands

This chapter lists add commands.

add ip arp

This command adds a static Address Resolution Protocol (ARP) entry to the device's ARP cache. The entry will not be timed out of the cache as is done with dynamic ARP entries. The entry will reside in the ARP cache until the device is rebooted; it cannot be saved in Flash ROM for subsequent installation

ARP is used to map high level IP addresses to physical addresses. The physical address may be either an IEEE Ethernet address or a Frame Relay DLCI which can be converted into a Frame Relay Q.922 hardware address. IP ARP is described in RFC 826.

add ip arp IP_address {Ethernet_address | DLCI}

Syntax Description

IP_address

Specifies an IP address to be associated with the hardware address in the ARP cache. It should be a legal IP address specified in dotted decimal format.

Ethernet_address | DLCI

  • Ethernet_address specifies an IEEE Ethernet address to be associated with the IP address in the ARP cache. It should be six hexadecimal octets separated by colons (:) or dots (.) ( i.e., 0:0:A5:0:0:1 or 0.0.A5.0.0.1).

  • DLCI specifies a DLCI address to be associated with the IP address in the ARP cache. The device will translate the DLCI into a Frame Relay Q.922 hardware address. The DLCI number must be between 16 and 1007.

Examples

add ip arp 192.15.8.100  0.0.A5.0.0.1
add ip arp 192.15.8.100  0:0:A5:0:0:1
add ip arp 192.15.1.100  16

Related Commands

Command Description

configure Frame Relay

Configures Frame Relay parameters for an interface

reset arp

Deletes ARP table entries

show arp

Shows the ARP table


hometocprevnextglossaryfeedbacksearchhelp
Posted: Wed Sep 27 11:08:20 PDT 2000
Copyright 1989-2000©Cisco Systems Inc.