Repacking the Box

If your system is damaged, you must repack it for return shipment. Use the original shipping containers. Figure B-1 shows an exploded view of the system and packing materials.

To return or move the Cisco 10000 ESR to a different location, follow these instructions for repacking the system, using the original packaging material:

Step 1 Place the bottom packing material section inside the bottom of the shipping container.

Step 2 Use at least two people to place the Cisco 10000 chassis inside the container. Be sure that the chassis is positioned correctly before you lower it inside the container (see Figure B-1).

Step 3 Place the top packing material over the top of the Cisco 10000 chassis (see Figure B-1).

Step 4 Place both accessory boxes inside the cutouts in the top section of the packing material (see Figure B-1).

Figure B-1: Cisco 10000 System and Packing Material

Step 5 Fold the outside carton down over the top of the accessory boxes and seal with packing tape (Figure B-2).

Step 6 Wrap two packaging straps tightly around the top and bottom of the package to hold the outside carton and the bottom pallet (Figure B-2).

Caution Do not use tape to hold the outside carton to the bottom pallet. Packaging straps must be used.

Figure B-2: Cisco 10000 System Package

Table of Contents

Repacking the Box

Repacking the Box