Table of Contents
Alarm Support Diagrams
Figure C-1: CONFIG FAIL - Configuration Load Failure - Information Alarm

Figure C-2: DISK - Low Disk Space - Major Alarm

Figure C-3: GEN FAIL - General Process Failure - Information Alarm
Figure C-4: IO CARD - IO Card Failure - Major Alarm

Figure C-5: LOG - Log File Open or Error - Major Alarm

Figure C-6: OS FAIL - Operating System Failure - Information Alarm

Figure C-7: SW FAIL - Software Failure - Information Alarm

Figure C-8: XE RSRL FAIL - XE Resource Failure - Information Alarm

Figure C-9: FAILOVER TO OOS - FAILOVER PEER_OOS - Information Alarm

Figure C-10: FAILOVERPEER - FAILOVER PEER Lost - Information Alarm

Figure C-11: PC UNAVAIL - Point Code Unavailable - Major Alarm

Figure C-12: RSET CONFIGFAIL - Route set Configuration Failure - Minor Alarm
Figure C-13: CHAN BAD TOT 15 - Channel TCA Total Frame Errors - 15 Min. Info Alarm

Figure C-14: CHAN BAD TOT 60 - Channel TCA Total Frame Errors - 60 Min. Info Alarm

Figure C-15: CHAN BAD TOT 24 - Channel TCA Total Frame Errors - 24 Hours. Info Alarm

Figure C-16: CHAN LINK ESTAB 15 - Channel TCA Link Established - 15 Min. Info Alarm

Figure C-17: CHAN BAD ESTAB 60 - Channel TCA Link Established - 60 Min. Info Alarm

Figure C-18: CHAN BAD ESTAB 24 - Channel TCA Link Established - 24 Hours. Info Alarm

Figure C-19: LIF FAIL - Line Interface Failure - Major Alarm

Figure C-20: LIF LOF - Line Interface Loss of Frame - Major Alarm

Figure C-21: LIF LOS - Line Interface Loss of Signal - Major Alarm

Figure C-22: LIF SES - Line Interface Severe Errored Seconds - Major Alarm

Figure C-23: LIF SES 15 - Line TCA Session 15 Minutes - Information Alarm

Figure C-24: LIF SES 60 - Line TCA Session 60 Minutes - Information Alarm

Figure C-25: LIF SES 24 - Line TCA Session 24 Hour - Information Alarm

Figure C-26: LIF YELLOW - Line Interface Yellow Condition - Minor Alarm

Figure C-27: SC CONFIG FAIL - Signal Channel Configuration Failure - Major Alarm

Figure C-28: SC FAIL - Signal Channel Failure - Major Alarm

Figure C-29: SC M-OOS - Signal Channel Manual Out of Service - Minor Alarm

Figure C-30: C7LNK ALGNMT LOST - Link Alignment Lost - Minor Alarm

Figure C-31: SOFTW NON - Non-Required Process Failure - Minor Alarm

Figure C-32: SOFTW REG - Required Process Failure - Major Alarm

Figure C-33: SUPPORT FAIL - Support Entity Failed - Minor Alarm

Figure C-34: START PROCESS - Procedure for starting an individual process or process group

Figure C-35: START MML - Procedure for starting an MML Session

Figure C-36: START CHANNEL - Procedure for placing a signaling channel in service

Figure C-37: START LINE - Procedure for placing a complete line in service

Figure C-38: START MANUAL - Procedure for manually starting procM process

Figure C-39: START TRANSPATH - Procedure for starting TransPath System Application

Figure C-40: STOP CHANNEL- Procedure for placing a signaling channel manually Out-Of-Service

Figure C-41: STOP LINE - Procedure for placing a complete line manually Out-Of-Service

Figure C-42: STOP MML - Procedure for stopping an MML session

Figure C-43: STOP PROCESS - Procedure for stopping an individual process or process group

Figure C-44: STOP TRANSPATH - Procedure for shutting down TransPath system

Copyright 1989-1998
©
Cisco Systems Inc.