|
|
This chapter describes how to use Telnet to access the Cisco 6510 Service Selection Gateway (Cisco 6510) command-line interface (CLI).
To access the Cisco 6510 with Telnet, follow these steps:
Step 1 Telnet to interface card 1 of the Cisco 6510.
The Cisco 6510 prompts you to enter the username.
Step 2 Enter root.
The Cisco 6510 prompts you to enter a password.
Step 3 Enter the password (default: admin).
The Cisco 6510 prompt (SSG >) appears.
Step 4 Make and save any configuration changes.
Step 5 When you are finished, enter:
To change the password, enter the following command from the SSG > prompt:
SSG > passwd
Old Password: *****
New Password: *****
Re-enter New Password: *****
Password changed.
To determine whether there is an active Telnet session to the Cisco 6510, enter the following command from the SSG prompt:
SSG > telnet show
If there is an active session, you can disconnect by entering the following:
SSG > telnet disconnect
|
|