Table of Contents

Product Overview
Key Features and Benefits
Specifications
Ordering Information

For Part Descriptions and Part Numbers for Cisco IP Telephony Solutions, see

Cisco DE-30+ — Digital IP Telephony Gateway

Product Overview

The Cisco DE-30+ digital gateway provides a connection path between the Cisco AVVID (Architecture for Voice, Video and Integrated Data) packet telephony network and the Public Switched Telephone Network (PSTN) or a PBX using digital (PRI ISDN) trunks. The DE-30+ supports 30 voice channels on an E1 interface. Gateways are managed, controlled, and administered through the required Cisco CallManager. The DE-30+ gateway consists of a single PCI bus-based card and mounts in any PCI bus-PC (where it only draws power).

Key Features and Benefits

The digital gateways include the following features:

• A single PCI-based card (PCI bus for power only) with the following components on board:

  Integrated digital signal processors (DSPs)

  E1 (RJ-48C female) interface

  10Base-T Ethernet network interface (RJ-45 female)

  Control processor with communications software to connect to the Cisco CallManager (required) over TCP/IP/Ethernet link

  Remote boot procedure with DHCP (for IP address) and TFTP software download (downloadable and upgradable)

• E1 PRI ISDN Layer 3 protocols, including National ISDN-2 (NI-2), 5 Electronic Switching System (5ESS), 5ESS custom, DMS100, DMS250, and other protocol support

• Both user-side and network-side ISDN signaling support to emulate either terminal equipment or switching equipment, respectively

• Supports Skinny Gateway protocol communications with Cisco CallManager to provide supplementary services (hold, transfer, etc.) under control of IP telephone clients

The Cisco access model DE-30+ (E1) allows customers to connect the Cisco AVVID packet telephony network to the PSTN or to a PBX. The physical circuit-switched interface is a single female RJ-48C interface. The circuit-switched signaling interface is E1 PRI ISDN. The DE-30+ gateway supports up to 30 simultaneous channels of voice over IP (VoIP) packet to circuit-switched adaption, G.711 encoding (A-law or m-law), dual tone multifrequency (DTMF) detection/generation, signaling, and line echo cancellation. A full 30 simultaneous channels of G.723.1 encode/decode are also supported.

The DE-30+ has been successfully connected to a wide variety of PBXs including:

• Nortel Meridian (all options)

• Lucent Definity (all G3 options)

• Ericsson MD110

• Siemens HiCom

• Rolm 9XXX

• Intecom E

• InterTel (using T1 PRI)

• Matra 6500

• Many others

The DE-30+ has also been connected to many public switches including:

• Lucent 4ESS and 5ESS

• Nortel SL1, SL100, DMS-100, and DMS-250

• DSC (Digital Switch DSC600E using T1 PRI)

The Cisco AVVID telephony solution provides a full featured telephony system running on an IP network. Various IP telephony devices including phones and gateways communicate seamlessly over IP infrastructures under the control of one or more Cisco CallManagers. This solution rewards users with greatly reduced cost of ownership and new IP-based feature capabilities. The DE-30+ digital gateways provide the ability to make and receive calls outside the IP network. These gateways provide the interface to the PSTN or existing PBX systems via ISDN PRI interfaces. They differ from the analog gateway products in that they support digital ISDN features including direct inward dial (DID, often called DDI) and caller ID. These features allow outside callers to dial directly to a particular user without going through an attendant (operator). In addition, digital interfaces usually provide a more economical interface choice when the number of trunks exceeds six to eight channels.

When deployed in a network, the DE-30+ Digital Gateways can be located in any convenient PCI bus-based PC. They simply draw power from the host PC and are completely managed via browser access through the Cisco CallManager. Because they only draw power, they do not affect the performance or operation of the host PC, nor do they require any special software or drivers. They may even be installed in the Cisco CallManager itself.

When more than one DE-30+ gateway is needed, it can be treated as a separate gateway or aggregated together with others as a common pool of channels. Any number of digital gateways can be installed in a network, and the number installed in a PC is only limited by the number of available slots.

The DE-30+ communicates with the Cisco CallManager, which allows the implementation of supplementary services such as hold, transfer, and forward on outside calls. Also, with proxy signaling provided by the Cisco CallManager, the DE-30+ is fully H.323 V.2 compatible.

• Simple PCI bus installation

  Installs in any PCI bus-based PC. The card only draws power, so no drivers or software need to be installed

  Does not interfere with the performance or operation of the host PC

  Can be mounted in the Cisco CallManager PC or any other convenient PC

  For high-density applications, simply install more cards in the same PC up to the max number of slots

• PRI ISDN (T1/E1 rate) trunk interface through female RJ-48C interface

  Both user-side and network-side Q.931 signaling (software selectable)

  Support for National ISDN-II (NI-2), DMS, and 5ESS variants

• Adds convenient call features to the IP telephony system

  Caller ID (name and number, inbound and outbound)

  Direct inward dialing

  Supplementary services for outside calls (hold, transfer, forward, conference) under control of the Cisco CallManager

  Per port management and backhaul of the signaling channel to the Cisco CallManager for complete control

  Follows Cisco CallManager failover scenario—when Cisco CallManager switches to backup, the card registers with the new Cisco CallManager

• Standard management features

  Completely manageable from the browser-based Cisco CallManager

  Ethernet device status LEDs (Ethernet link, Ethernet transmit/receive)

  Trunk status LEDs

• Network/application aware

  H.323 compatible when used with Cisco CallManager

  DHCP client—for IP address acquisition

  Locates Cisco CallManager via DHCP or DNS

  Automatic TFTP software and configuration download upon boot up if necessary

  Automatic registration with Cisco CallManager

Cisco support solutions are designed for one purpose—to ensure customer success by delivering a suite of proactive support solutions. Cisco support solutions offer presales network audit planning, design consulting, network implementation, operational support, and network optimization. Leveraging Cisco expertise and experience, customers gain interactive knowledge transfer solutions to enhance their success. By including support with Cisco equipment purchases, customers immediately gain access to a wealth of support and resources.

Specifications

Ordering Information

For Part Descriptions and Part Numbers for Cisco IP Telephony Solutions, see

Part Descriptions and Part Numbers for Cisco IP Telephony Solutions

Posted: Wed Sep 27 05:15:34 PDT 2000
Copyright 1989-2000©Cisco Systems Inc.