|
|
The Cisco ONS 15304 is an optical transport extender that allows service providers to extend optical transport capabilities to customer premise facilities. The Cisco ONS 15304 Optical Transport Extender combines the powerful data features of Cisco IOS software with the ring capabilities of a Synchronous Digital Hierarchy (SDH) Add/Drop Multiplexer (ADM). The Cisco ONS 15304 allows provisioning of native private line E1 as well as next-generation, high-margin, data-based services using a single redundant platform deployed in the existing service provider transport network. Eight E1 and eight 10BaseT Ethernet ports Standards-based and interoperable with the existing SDH equipment Cisco IOS software-based packet processing Fully redundant platform with no single point of failure including: processor, E1, Ethernet, and fiber interfaces Point-to-network operation that does not require Cisco ONS 15304s at each end of the connection Lower initial equipment procurement cost due to platform integration Single management application for SDH and service interfaces Alarm contacts and site alarm inputs Fiber is widely deployed in service provider networks in metropolitan areas and additional deployment continues. However, today`s SDH ADMs are not designed to address the increasing demand for the dominant revenue-generating data services. Widespread deployment of these services prompts the need for data-intelligent customer located equipment (CLE). The Cisco ONS 15304 combines the features of a Cisco IOS software-based bridge or router and a SDH ADM in an integrated platform that is deployable from the edge of the network. Service providers benefit from enhanced bandwidth utilization through the use of wideband packet over SDH technology. The Cisco ONS 15304 provides private line E1 as well as data-aware 10BaseT Ethernet ports for service delivery. The Cisco ONS 15304 operates with a G.813 compliant (2.048 MHz) clock with full support for synchronization status messaging (SSM). A unique autoprovisioning feature provides fast and easy system turnup. Designed to be deployed directly on the service provider network infrastructure, the Cisco ONS 15304 is engineered on accepted industry standards from the European Telecommunications Standards Institute (ETSI) and the International Telecommunications Union (ITU). The Cisco IOS software-based data processing features comply fully to existing IETF RFCs as well as relevant Institute of Electrical and Electronic Engineers (IEEE) standards. The Cisco IOS software has emerged as the industry`s accepted standard for internetworking at all points from the desktop to the Internet backbone. The Cisco ONS 15304 is another platform that leverages this functionality. Therefore, operations personnel trained on Cisco IOS software will find it very easy to provision and manage the Cisco ONS 15304 saving significant training costs for service providers. The SNMP agent software in the ONS 15304 supports standard MIBs and can be managed by the Cisco Transport Manager (CTM) or by industry standard SNMP managers. For more information on CTM, see New Product: Cisco Transport Manager 2.0 Cisco ONS 15304 — Optical Transport Extender
Product Overview
Highlights
Key Features and Benefits
TDM and Data Service Delivery on Existing SDH Networks
Fully Interoperable Standards-Based Design
Cisco IOS Software and Element Management
|
Feature |
Description |
Benefit |
|---|---|---|
|
Integration of Private-Line and Data Capabilities within an SDH ADM |
Consolidation of data-equipment and transport ADM into a single network element. |
Reduction in network cost and complexity. |
|
Scalable Data Bandwidth |
End customers can subscribe to data connections in 2 MB increments. As their needs grow, additional 2 MB increments can be remotely provisioned. |
Service activation of additional bandwidth can be performed from a remote location and without equipment replacement. On-site upgrade/maintenance is not required, speeding the service delivery interval. |
|
Data Transmission Across Carrier-to-Carrier Boundaries |
Because PPP/MLPPP streams are encapsulated by framed E1s, data services can be seamlessly transported across carrier-carrier interfaces in a multiple of formats: within an E3 or as (multiple if MLPPP) E1s. |
This allows the carrier to create and offer services beyond their traditional network boundaries. |
|
Transport Layer Survivability |
The system supports transport layer protection according to the ITU Recommendation G.841. |
The carrier can integrate the product into an SDH network and provide physical layer protection for higher services availability. |
|
Automatic Smart Alarming and PM (ASAP) |
The system automatically turns on performance monitoring and alarming when service is applied. |
Traditional configuration of E1 services requires the carrier to provision the service twice. Once where the carrier validates the service (and then turns off alarming and PM) and again when the end-customer turns up service (where the carrier turns alarming and PM back on). With ASAP, service is only provisioned once. |
|
Fast and Automatic System Turn-up |
The system supports auto-provisioning allowing craft-persons to quickly install and provision the system for service. The craft mounts the system and connects the facilities, enters the system into service, assigns a system name and IP address. Once this is done, ring service is up and all system provisioning can be performed from a remote operations center. |
Faster service provisioning allows providers to quickly install and turn-up equipment for services delivery. |
|
Integrated System Security |
The system supports three security levels for system users: Administrative, Provisioning and Maintenance. |
The system supports integrated security that prevents unauthorized craft and end-customers access to the system. |
|
Description |
Specification |
|---|---|
|
Interfaces |
Eight redundant 10BaseT Ethernet Ports Eight redundant E1 ports 50-pin CHAMP facility connections or as an option DB and RJ 45 connectors in a separate I/O Panel |
|
Network Management |
Simple Network Management Protocol (SNMP) SDH MIB RFC 1595 Management Information Base (MIB-II) Full SDH DCC management support Cisco Transport Manager (CTM)---Element Management System For more information on CTM, see New Product: Cisco Transport Manager 2.0 |
|
Description |
Specification |
|---|---|
|
Power |
-48 V DC to -60 V DC via dual independent feeds Front panel connection and fusing <100 Watts power dissipation (max.) |
|
Description |
Specification |
|---|---|
|
Dimensions (H x W x D) |
3.5 x 11 x 17.5 in. (8.9 x 28 x 44.5 cm) |
|
Weight |
18.7 lbs. (8.5 kg) |
|
Operating temperature |
32 to 113°F (0 to 45°C) |
|
Relative humidity operation |
0 to 95%, non condensing |
|
Description |
Specification |
|---|---|
|
Safety |
IEC 950 UL/cUL 1950 EN 60950 IEC 60950 AS/NZS 3260 ACA TS 001 |
|
EMI |
FCC class A EN55022 class A ENV 50141 EN 61000 |
|
Compliancy |
G.707 STM-1/VC-12 SDH, G.841/803 SDH Protection G.783 General Aspects of Digital Transmission Systems; Terminal Equipment G.813, & G.825 synchronization E1 ITU G.704 and G.703 Ethernet G.706 IEEE 802.3 10BaseT |
|
Encapsulation |
RFC 1663, Point-to-Point Protocol reliable transmission RFC 1662, Point-to-Point Protocol in HDLC-like framing RFC1990, MultiLink PPP (MLPPP) |
|
Description |
Specification |
|---|---|
|
Parameter |
Short Haul 1270-1380 nm SH-1 |
|
Line Rate |
155.52 Mbps |
|
Connector type |
FC or adaptation in the I/O Panel to specific Connectors |
|
Launch power (max) |
-5 dBm |
|
Launch power (min) |
-12 dBm |
|
Receiver power (max) |
-5 dBm |
|
Receiver power (min) |
-29 dBm |
|
Power budget |
17 dB |
For more information on Cisco software products, visit http://www.cisco.com/univercd/cc/td/doc/pcat/#3
| Part Description | Part Number |
|---|---|
| Cisco ONS 15300 Series Product | |
| Initial System Configuration | CISCO15304 |
| Cisco ONS 15304 Redundant Series | |
| Fully Equipped Redundant 15304 | 15304-R-FC |
| Non-Redundant 15304 | 15304-NR-FC |
| Cisco ONS 15304 Spares | |
| ETSI IO Panel For 15300 Series | 15300-I/O-PANEL |
| STM-1 Access Module For 15304 | 15304-SAM-FC= |
| Cisco Transport Manager | |
| Cisco Transport Manager R2.0 - Baseline System Pkg. | CTM-2.0-BLS |
| Additional CTM Client R2.0 - 10 Blk. | CTM-2.0-010 |
| Additional CTM Client R2.0 - 25 Blk. | CTM-2.0-025 |
| Additional CTM Client R2.0 - 50 Blk. | CTM-2.0-050 |
| Additional Cisco 1530X RTU License - 25 Blk | CTM-1530X-025 |
| Additional Cisco 1530X RTU License - 50 Blk | CTM-1530X-050 |
| Additional Cisco 1530X RTU License - 100 Blk | CTM-1530X-100 |
| Additional Cisco 1545X RTU License - 25 Blk | CTM-1545X-025 |
| Additional Cisco 1545X RTU License - 50 Blk | CTM-1545X-050 |
| Additional Cisco 1545X RTU License - 100 Blk | CTM-1545X-100 |
| Additional Cisco 1545X RTU License - 500 Blk | CTM-1545X-500 |